MIDLAND BR777 - Manual (Page 18)

PROGRAMMING THE VOX (HANDS-FREE TRANSMISSION)
Your BR777 radio has 3 VOX level settings (oF/1/2/3).
In the PROGRAM mode, press the MODE button until the “VOX”
icon appears while the current VOX setting appears on the right.
Press the
S\T button to select between “0”, “1”,”2”, or “3” VOX
setting.
Press the MODE button again to continue programming.
Note : VOX will be more sensitive on the “1” setting than on the “3”
setting. Selecting “0” will disable the VOX function, and the VOX
icon will not appear on the display during operating.
CLONING THE RADIO SETTINGS
You can copy the BR777 radio settings from one radio (SOURCE) to
another BR777 radio (TARGET) by using a Cloning Cable.
Note to start the Cloning Process without the Cloning Cable
attached to the radios.
To clone the radios:
- Set both the SOURCE and TARGET radio into PROGRAM mode.
- Press the MODE button of both radios until the CLONE icon (shown
as “CLON”) appears on the right, and below a “CL” is shown.
- Press the
Tbutton of the TARGET radio and the RX icon will appear.
- Press the
Sbutton of the SOURCE radio and the TX icon will appear.
- Attach the Cloning Cable on both radios.
- Press again the
Tbutton of the TARGET radio and you will see 4
segments blinking in sequence in the LCD display.
- Press again the
Sbutton of the SOURCE radio and you will see 4
segments blinking in sequence in the LCD display.
- Once the cloning process is done, a “P” will appear on the display.
- Remove the cloning cable from the radios.
- Exit the cloning process by pressing the MODE button for more than
3 seconds until the unit is powered off.
Page 16 www.bluestarcomm.net
Model BR777
!