Michelin X970 - Manual (Page 9)

2_Installation in the vehicle
2.1 Button and sockets
You will find the visual presentation of the various elements making up your ViaMichelin Navigation
X-970 on the installation diagram.
• On the top: On/Off button To switch the device on or off.
• On the left side: SD card reader For SD cards with a storage capacity of up to 2 GB.
• Under the device: Audio socket Use this 3.5 mm jack to connect an earphone for audible alarms.
Mini-USB port To connect your ViaMichelin Navigation X-970 to your PC using
the USB cable provided.
Power connector To connect the cigarette lighter cable supplied with your device
or a power adapter.
• Mounting system
connection socket
This socket provides the connection between the parts in the car mounting system
and the device. It is also used to connect the antenna to receive
traffic information (an option that will be available via a separate
accessory at a later date).
• At the back of your device:
Antenna socket This socket is not currently used.
Reset In certain situations, it may be necessary to reset the PND; to
reset the device (soft or hard reset), see the information in the
table in chapter 15.
• On the car mounting system (below):
Mic socket This socket is not currently used.
TMC socket This socket is not currently used.
Power connector Used to connect the cigarette lighter cable and the power adapter
supplied with your ViaMichelin Navigation X-970.
Comments:
The power adapter contains the transformer used to supply and recharge the battery in your device. It must be
installed near your PND and be accessible so that you can disconnect the device easily.
Disconnect the power adapter first before disconnecting the PND cable.
7