How to mount and attach options to the lcd monitor, English, Ventilation requirements for enclosure mounting – MITSUBISHI ELECTRIC LDT46IV User Manual
Page 14
English
English-13
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the equip-
ment or injury to the user or installer. Product warranty does
not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
Use M6 mounting screws (having a length 10 mm longer than
the thickness of the mounting bracket) and tighten them se-
curely. (Recommended torque: 470 - 635N•cm). MITSUBISHI
ELECTRIC recommends using mounting interface that comply
with TÜV-GS and/or UL1678 standard in North America.
Caution:
For preventing the monitor from falling.
• Install the monitor with metal brackets for wall or ceiling
installation (commercially available) on your own respon-
sibility. For detailed procedures of installation, refer to the
instructions of the metal brackets.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• To lessen the risk of falling of the monitor, thread commer-
cially available rope (having a load capacity at least 1960N
(200kgf)) through the handles at the right and left of the
monitor and secure the rope to the wall mount brackets or
ceiling mount brackets.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
4. To avoid monitor from falling
Take measures to prevent the monitor from falling over in case
of an earthquake or other disaster to lessen the probability of
injury and damage resulting from fall.
As shown in the fi gure, secure the monitor to a solid wall or
pillar using rope (commercially available) strong enough to
bear the weight of the monitor. (LDT461V: approx. 34.6 kg)
When you use screw hooks (commercially available), ring
screw hooks, not C-shaped screw hooks (with opening), are
recommended.
Caution:
• The effectiveness of preventing from falling substantially
depends on the strength of brackets and base to which
prevention device from falling is attached. When you
cannot ensure suffi cient strength, provide adequate
reinforcement.
• Though the recommended prevention from falling is
intended to lessen the probability of injury and damage, it
doesn’t assure its effectiveness against any kind of
earthquake or disaster.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
• Before moving the monitor, remove the rope that is
securing the monitor. Failure to do so may result in injury
or breakdown of the monitor.
How to Mount and Attach Options to the LCD Monitor
Screw Holes
768 mm
Clamper
Rope, etc.
commercially available
Screw
Screw hook, etc.
commercially available
Protective
Sheet
Tabletop Stand
Handles
Table
561
561
100 100 100 100
100
100
331.5
331.5
(mm)