beautypg.com

Setup procedure, Determine the installation location, Install the remote control batteries – MITSUBISHI ELECTRIC LDT46IV User Manual

Page 11: Connect external equipment (see page 14-18), Connect the supplied power cord, Operate the attached external equipment

background image

English-10

1. Determine the installation location

CAUTION:
DO NOT ATTEMPT TO INSTALL THE LCD MONITOR BY
YOURSELF.
Installing your LCD display must be done by a qualifi ed
technician. Contact your dealer for more information.

CAUTION:
MOVING OR INSTALLING THE LCD MONITOR MUST BE
DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD
monitor falls.

CAUTION:
Do not mount or operate the display upside down, face up, or
face down.

CAUTION:
Do not install the LCD monitor where it will be exposed to
direct sunlight, as this will result in display defects.

CAUTION:
This LCD has a temperature sensor and cooling fan. If the
LCD becomes too hot, the cooling fan will turn on automati-
cally. If the LCD becomes overheated and the cooling fan
is running, the “Caution” menu will appear. If the “Caution”
menu appears, discontinue use and allow the unit to cool.
When the LCD monitor is used in an enclosure or with protec-
tion on LCD surface, please check the inside temperature of
monitor by “HEAT STATUS” (See page 29). The temperature is
too hot than normal condition, please set “cooling fan” to ON
on SCREEN SAVER function (See page 26).

IMPORTANT:
Lay the protective sheet, which was wrapped around the LCD
monitor when it was packaged, beneath the LCD monitor so
as not to scratch the panel.

2. Install the remote control batteries

The remote control is powered by 1.5V AAA batteries.
To install or replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–) indications

inside the case.

3. Replace the cover.

CAUTION:
Incorrect use of batteries can result in leaks or bursting.
Be careful especially about the following points.
• Place “AAA” batteries matching the + and - signs on each

battery to the + and - signs of the battery compartment.

• Do not mix battery types.
• Do not combine new batteries with used ones. It causes

shorter battery life or leakage of batteries.

• Remove dead batteries immediately to prevent battery

liquid from leaking into the battery compartment. Don't
touch exposed battery acid, it cause damage to your skin.

NOTE:
If you do not intend to use the Remote Control for a long
period, remove the batteries.

3. Connect external equipment
(See page 14-18)

• To protect the connected equipment, turn off the main

power before making connections.

• Refer to your equipment user manual.

4. Connect the supplied power cord

• The power outlet socket should be installated as near to

the equipment as possible, and should be easily

accessible.
• Fully insert the prongs into the power outlet socket.

Loose connection may cause noise.

NOTE:
Please refer to “Safety Precautions, Maintenance &
Recommended Use” section of this manual for proper
selection of AC power cord.

5. Switch on the power of all the
attached external equipment

When connected with a computer, switch on the power of the
computer fi rst.

6. Operate the attached external equipment

Display the signal on the external equipment you wish.

Setup Procedure

Clamper

Cable Holder