Multi-Tech Systems MT2456SMI22 - Manual (Page 32)

Chapter 4 - V.22bis Commands
Multi-Tech Systems, Inc. MT2456SMI-22 SocketModem Developer’s Guide 32
+ITF Transmit Flow Control Thresholds
The +ITF command determines the flow control thresholds used by the modem for transmit data from the DTE. This
optional compound parameter allows the DTE to determine the input buffer size in the modem for data on circuit 103
(transmit data) from the DTE, to control the thresholds used for flow control of such data, and to control how often the
modem reports to the DTE the number of octets in this buffer. The DTE can adjust its own thresholds for flow control
of data on circuit 104 (received data) from the modem.
Syntax
+ITF=[[,[,]]]
Defined Values
Determines the threshold, in octets, above which the modem will generate a flow off signal. Applicable in
Synchronous Access and Frame Tunneling modes. Default value is 255.
For the and subparameters, the input buffer is assumed to reside between the modem’s V.24
interface and the Synchronous Access protocol layer; i.e., the buffer count includes all octets, including EM
codes, received from the DTE, with the exception of DC1 and DC3 if these are used to signal DTE> flow control.
The modem returns the ERROR result code if the DTE specifies that the subparameter be set to a value
less than or equal to the subparameter; in this case, the current parameter value settings are not
modified.
Determines the threshold, in octets, below which the modem will generate a flow on signal. Applicable in
Synchronous Access and Frame-Tunneling modes. Default value is 64.
Not supported. A fixed value of zero is used and reported.
Reporting Selected Options
The modem sends a string of information text to the DTE consisting of selected options in response to the following
command:
+ITF?
The response is:
+ITF: ,,
Example:
+ITF?
+ITF: 255,64,0 Default values
Reporting Supported Options
The modem sends a string of information text to the DTE consisting of supported options in response to the following
command:
+ITF=?
The response is:
+ITF: (list of supported values),(list of supported values),(list of supported values)
Example:
+ITF=?
+ITF: (0-255),( 0-255),(0)
The maximum reported value is the input transmit data buffer level at which the modem signals a transmit data
overrun indication to the DTE.