Metrologic Instruments MS9524 - Manual (Page 12)

8
I NSTALLING THE S CANNER TO THE H OST S YSTEM
Integrated Full Speed USB MS9524-40 and MS9544-40
1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector
of the USB cable into the jack on the
Voyager
PDF . You will hear a ‘click’ when
the connection is made.
3. Connect the other end of the USB cable to
the host USB port.
4. Turn on the host system.
Plugging the scanner into a port on the
host system does not guarantee that
scanned information will be
communicated properly to the host
system. The scanner is shipped from the
factory programmed with default settings.
Please refer to the MetroSelect
Programming Guide
(
MLPN 00-02544) or MetroSet2’s help files
for instructions on changing the scanner’s
configuration. In addition, please check
that the scanner and host system are
using the same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.
Installation Notes for the MX009 USB Converter Cable
Metrologic’s MX009 USB cable is a device that converts serial RS232 formatted
data to either USB Keyboard or USB Point-of Sale communication protocol.
Please refer to the MX009 USB Converter Cable Programming Guide
(
MLPN 00-02574) supplied with your MX009 cable for detailed installation and
programming guidelines.
Figure 7.