MITSUBISHI ELECTRIC WS-65909 - Manual (Page 77)

77 77
Appendix E: Diamond Shield Instructions
A
p
p
e
n
d
ix
E
:
D
ia
m
o
n
d
S
h
ie
ld
In
s
tr
u
c
tio
n
s
Diamond Shield™ Installation
The instructions below will lead you through the
Diamond Shield installation process. Included
in the Diamond Shield package are the following
items:
For model WS-65869 only.
(1) Diamond Shield™
(2) molding clips
1
Carefully remove the Diamond Shield™ from
its protective packaging. Wipe off any dust with
a lint-free cloth.
2
Begin by inserting the shield, sliding it into
the channels, starting at one side. Gently bow
the Diamond Shield™ toward you and insert the
side of the Diamond Shield™ into side channel
then install the opposite side.
3
Install the top and bottom molding clips by
pressing them into the opening, starting at a
corner. Do not force the clip. The clip will slide
into place. This completes the Diamond Shield™
installation.
To remove the Diamond Shield™, reverse
the order of the above process.
Diamond Shield™ for the model
WS-55859 comes installed by the factory.
for Models WS-55859
& WS-65869