MITSUBISHI ELECTRIC WS-65909 - Manual (Page 66)

66 66
Figure 1. Programming the remote to control your Net-
Command™ A/V devices.
Part IV: Operation
P
ro
g
ra
m
m
in
g
R
e
m
o
te
C
o
n
tr
o
l
Programming the Remote Control to Control NetCommand™ A/V
Products
To Program the Remote to Control
NetCommand A/V Products:
(See NetCommand Supported Devices, page 16, for
the list of A/V products supported by the NetCom-
mand System.)
1
Move the slide switch at the top of the
remote to the TV layer.
2
Press and hold the POWER button on
the remote control.
3
Enter the three digit code of 935, and
then release the POWER button on the
remote control.
4 The remote control is now programmed
to send NetCommand™ signals to the
TV so the TV can control the IEEE
1394 devices and selected older Net-
Command™ supported IR devices. See
the NetCommand™ guide for details.