MITSUBISHI ELECTRIC WS-65909 - Manual (Page 34)

34 34
Part II: Installation
T
h
e
N
e
tC
o
m
m
a
n
d
™
S
e
tu
p
:
E
d
it
S
c
re
e
n
s
The NetCommand™ Setup: Edit Screens
Name
Figure 1
The Name screen allows you to change the
default name for each device to a custom
name of up to eight characters, selecting
from letters, numbers, and nine different
characters. Use to select each letter,
then press ENTER to move to the next
letter position. Press CANCEL to delete the
current letter and move back one letter posi-
tion. When in the rst posi tion, the CANCEL
button will return the name to the original
default name.
Connection
Figure 2
The Connection screen allows you to
change the connections to the TV inputs
and A/V Receiver inputs, and select if audio,
video or both are connected to the inputs.
Figure 2 uses a cable box as an example.
Check the “RF” box if you send the output
of your cable box to the TV on channel 3,
4, or 5. Then select the antenna and the
device name for the VCR connected to the
cable box. Uncheck the “RF” box if you
send the audio and video to your TV and
A/V Receiver using audio and video cables.
When connecting other devices, the “RF”
box is not displayed. If “RF” is unchecked,
or for any other device, select the inputs
on the TV and A/V Receiver connected to
the device. Then check the “Video” and/or
“Audio” boxes that match your connections.
Channel
Figure 3
If the device being connected is a cable box
and the “RF” box (on the previous screen) is
checked, the Channel screen allows you to
select the channel number that is used for
output by your cable box when the cable box
is connected through Ant-A or Ant-B.
Figure 1. Name menu.
Figure 2. Connection menu.
Figure 3. Channel menu.