Motorola 2700 - Manual (Page 2)

portable broadcast unit manual V 1.0 2
Reporter Set Motorola 2700 portable version
Connection and operation instructions
notice:
Please, take care of the safety advices in the original Motorola 2700 operating instructions !
Refer to the original Motorola 2700 instructions manual for detailed installation instructions
of the car kit.
The battery features in the `Phone Setup Menu´ like: `Battery Meter´ and `Battery Saving Mode´
are only available, if no external power supply is connected.
Always disable the `call waiting´ - function of your SIM-card. This might cause trouble while
using the `
Reporter Set´ .
Type `#43#´ on the handset and press the `OK´ - button. Wait a few seconds, the change will be
confirmed by the network then.
operation:
Insert a valid SIM card into the cardreader and connect the audio devices to the audio connectors.
By switching on the mobile phone on the handset the
Reporter Set is also ready-to-operate.
A connection set-up is done with the handset of the mobile phone as it is described in the
Motorola 2700 manual.
A running call can be taken over to the connected microphone and headphone by a push to
the take over switch (refer to the frontpanel view ).
The operation mode „headset activ“ is indicated by the red LED beside the take over switch.
If the handset is hooked up during a runnig transmission the LF can alternate from handset
to audio connectors (headphone/microphone) by pressing the take over switch.
The transmission can be quit with the take over switch if handset on hooked.
The volume of the connected headphone can be adjusted with the volume knob on the frontpanel.
Please notice! The volumes preset of the Motorola handset influences the headphone loudness too.
The push button "microphone on - off " mutes or unmutes the connected microphone.
"off" is indicated by the flashing red LED beside the mute button.
Four default volume settings can be adjusted within the
Reporter Set:
1. outgoing microphon volume * * * 1
2. microphon volume to headphone * * * 2
3. outgoing aux-in volume * * * 3
4. aux-in volume to headphone * * * 4
Factory set is "5".
An adjustment must be done during a running call and the LF taken over to the audio connectors.
Select the character string of the volume preset that is to be adjusted.Type digits on the handset
keyboard (for exsample * * * 1 ). The settings can be changed by pressing the numeric keys 1-9
(steps of 2,5 dB). Quit the adjustment by pressing the „C“ button long.