Customer setup menu – MITSUBISHI ELECTRIC 882.00273.00 User Manual
Page 90
Customer Setup Menu
Units
This screen allows the user to change the blender’s unit of measurement. The entire blender
can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be configured
for either regardless of the blender’s units.
Figure 73: Typical Units Screen
Network Setup
This screen allows the blender to be configured for use with the Ethernet Option. The
blender will automatically configure the Ethernet module’s IP Address and Subnet Mask if
the configurator is enabled. Whenever you modify the IP Address or subnet, you either need
to reboot the PLC.
Figure 74: Typical Ethernet Setup Screen
Change Target vs.
Actual Units
Change
Blender’s
Units
Go back to
Setup
Directory
Go back to Setup
Directory
Enable or
Disable the
Ethernet
Module
BF1-615.3
Chapter 7: 6BAppendix
90 of 101