MITSUBISHI ELECTRIC 882.00273.00 - Manual (Page 61)

Figure 48: Typical Recipe Book Operator Screen
Erase One
Stored
Recipe
Select a Stored
Recipe
Stored Recipe
Details
Erase Entire
Book
Load Stored
Recipe
Go to Recipe
Page
Save Running Recipe to the Book
The save current recipe to book function allows the operator to save the contents of the
current recipe to the recipe book under a desired number.
Upon selecting this function, the operator will be prompted for a reference recipe number.
This may be any number from 1 to 50.
The assigned recipe number will be used for all further references to this recipe until deleted.
The operator should be familiar with the recipe numbers used. We suggest keeping a loose-
leaf notebook with 50 tabbed pages as a reference to what is kept in the blender so this can be
the standard for all blenders in the plant, etc. To save a running recipe to the Recipe Book
perform the following steps:
1. Enter the Recipe Book by touching the Recipe Book icon located on the Recipe
Screen.
2. Select a stored recipe by changing the number next to “Recipe #.”
3. Touch “Save Running Recipe” and then “Done”.
Load a Saved Recipe from the Book
The load from book function allows the operator to retrieve a previously stored recipe from
the recipe book and install it into the current recipe menu. This will overwrite the current
recipe, so make sure that it has been saved to the book before installing a new recipe in its
place. To load a previously stored recipe from the Recipe Book:
1. Enter the Recipe Book by touching the Recipe Book icon located on the Recipe
Screen.
2. Select a stored recipe by changing the number next to “Recipe #.”
3. Touch “Load” and then “Done” (this takes you back to the Recipe Screen).
4. Touch “Accept New Recipe” to accept the loaded recipe into the blender.
Note: If replacing the current recipe with one that is downloaded from the
Recipe Book, make sure that the previous recipe has been saved, as it
will be overwritten by the new downloaded recipe.
Display Recipe Contents
The display recipe function is used to verify the contents of a recipe number before it is
loaded from the recipe book. In order to view the desired recipe, the operator must enter the
BF1-615.3 Chapter 4: 3BOperation 61 of 101