Mark Levinson 53 User Manual
Page 24
20
Mark Levinson
5. The Home tab of the amplifier’s internal Web page is now
displayed. The tab is in red text to indicate that it is the current
page.
6. Observe that the Status section of the Web page identifies the
host name of the amplifier. The host name can be modified, but
only the first eight characters are affected; anything after the
underscore may not be modified.
To change the host name of the
amplifier:
A. Type the new name into the white box to the right of the
parameter. The new name must be made from the capital
letters, A to Z, and the numbers, 0 to 9. Underscores may also
be used. Only eight characters are allowed.
Note
The host name MUST start with an alpha-character (A to Z). This is a
standard networking rule.
B. Click the Submit button to save the new value.
C. Click the Refresh button in the Status section of the Web
page to observe the new host name.
7. Observe that the Status section of the Web page also identifies
the static IP address of the amplifier. The static IP address can be
modified, if desired.
To change the IP address of the amplifier:
A. Type the new IP address into the white box to the right of the
parameter.
B. Click the Submit button to save the new value.
C. Enter the new IP address of the amplifier into the browser.
The amplifier Web page loads, reflecting the new
information.
The network connection is now complete.