Mark Levinson 53 User Manual

Page 23

Nº53 Power Amplifier

8. Observe that the Status section of the Web page identifies the

host name of the amplifier. The host name can be modified, but
only the first eight characters are affected; anything after the
underscore may not be modified.

To change the host name of the

amplifier:

A. Type the new name into the white box to the right of the

parameter. The new name must be made from the capital
letters, A to Z, and the numbers, 0 to 9. Underscores may also
be used. Only eight characters are allowed.

Note

The host name MUST start with an alpha-character (A to Z). This is a
standard networking rule.

B. Click the Submit button to save the new value.

C. Click the Refresh button in the Status section of the Web

page to observe the new host name.

9. Observe that the Status section of the Web page also identifies

the IP address of the amplifier. The static IP address can be
modified, if desired.

To change the IP address of the amplifier:

A. Type the new IP address into the white box to the right of the

parameter.

B. Click the Submit button to save the new value.

C. Enter the new IP address of the amplifier into the browser.

The amplifier Web page loads, reflecting the new
information.

The network connection is now complete.

Direct Connection

Use this procedure to connect directly to a computer if you are not
using a router. For the computer to find the amplifier, the TCP/IP
and LAN settings of the computer must be set up. Refer to the
earlier “Setting up the Computer” procedure for instructions.

1. Connect the amplifier to the computer, as described in the

earlier “Connecting the Cables” procedure. Make sure that both
the amplifier and the computer are powered off before
connecting.

2. Press the Power button on the amplifier.

3. On the computer, open the Internet Explorer Web browser.

4. On the address (URL) line, type in the static IP address of the

amplifier and press Enter. There may be a short delay before the
amplifier Web page loads.