MITSUBISHI ELECTRIC PD-4265 - Manual (Page 20)

11
Basic Operations
POWER
To turn the unit ON and OFF:
1. Plug the power cord into an active AC power outlet.
2. Press the POWER ON button (on the remote control)
to turn on the unit.
The monitor’s POWER/STANDBY indicator will light
up (green) when the unit is on.
3. Press the POWER STANDBY button (on the remote
control) to turn off the unit.
The monitor’s POWER/STANDBY indicator turns red
and the standby mode is set.
VOLUME
To adjust the sound volume:
1. Press and hold the VOLUME button (on the remote
control or the front panel) to increase the volume to the
desired level.
2. Press and hold the VOLUME button (on the remote
control or the front panel) to decrease the volume to
the desired level.
MUTE
To cancel the sound:
Press the MUTE button on the remote control to cancel
the sound; press again to restore.
INFO
To check the settings:
1. The screen changes each time the INFO button is
pressed.
2. If the button is not pressed for approximately three
seconds, the menu turns off.
DIGITAL ZOOM
Digital zoom specifies the picture position and enlarges
the picture.
1. Press the ZOOM ( or ) button to display the
magnifying glass. ( )
To change the size of the picture:
Press the ZOOM button to enlarge the picture.
A press of the ZOOM button will reduce the
picture and return it to its original size.
To change the picture position:
Select the position with the
▲▼ ᮤ ᮣ buttons.
2. Press the EXIT button to exit the ZOOM mode.