Monarch Instrument Paxar 9450 User Manual
Page 12
If the battery loses power in the middle of a printing session,
replace or recharge the battery. The printer remembers the
print job.
When you use or store your charger, do not:
✦
wrap the cord around the charger.
✦
pull or put unusual stress on the cord.
w
Before using the charger, inspect the cord for bare wires. Do
Not use a charger with bare wires. Only use a charger
approved for use with this printer.
To charge the battery:
1. Remove the battery, as described in "Removing the
Battery."
2. Plug the small, round connector on the charger cord into
the socket on the battery, as shown. The charger’s LED
indicator is solid amber when the charger is fully
connected.
3. Plug the charger into a 115V electrical outlet. A full initial
charge takes approximately 14 hours.
n
Areas using 220V or 240V electrical outlets will receive a
charger designed for these voltages. See Chapter 7,
"Specifications," for information.
Small Round
Connector
Socket
9450 Operator’s Handbook
1-4