Mercedes-Benz SL-Class - Manual (Page 122)

120
Controls in detail
Memory function
With the memory switch you can store up
to three different settings per SmartKey or
SmartKey with KEYLESS-GO*.
The following settings are saved for each
stored position:
ț Driver’s seat and backrest position
ț Steering wheel position
ț Driver’s side exterior rear view mirror
position
ț Passenger side exterior rear view mir-
ror position
These key-dependent memory settings
can be deactivated if desired
(
୴ page 158).
The memory switch is located on the door.
M Memory button
1, 2, 3 Stored positions
̈ Switch on the ignition ( ୴ page 36).
or
̈ Open the respective door.
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach and com-
fort. The head restraint should also be
adjusted for proper height. See also the
section on airbags (
୴ page 63) for
proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the interior and
exterior rear view mirrors should be
adjusted for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standard 213 and Canadian Motor Ve-
hicle Safety Standard 213.
Warning!
G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.