Magellan 750M User Manual

Page 13

To temporarily attach the Display, follow these simple steps:

a) Locate the center (smaller) tab of the Quick Mount Bracket and bend it outward at

approximately a 45 degree angle.

b) Select a location that will provide optimum Display viewing.

c) Gently insert the center tab and push downward until the Quick Mount Bracket grips the

surface. The Display should be held snugly against the surface and face horizontally or
slightly upward.

d) If the Display faces too far down and is difficult to view, bend the center tab outward

further and bend both side (larger) tabs out as well. Try to maintain the approximate 45
degree angle between the center tab and side tabs. The angles between the Display back
and the side tabs may need to be adjusted for optimum fit.

When mounting the Display take care to ensure that it is clear of

vehicle operation, airbags and function controls.

Avoid excessive force in operation! Damage may result if excessive
force or leverage is applied.

Take care when removing or replacing the Quick Mount Bracket
and be aware that heavy accidental impacts may result in damage.

Do not mount display in a place or manner where driver or
passengers are likely to have an impact with the display in a
collision or during heavy braking.

Securely mount the display in a manner which will not allow the
display to become a projectile in a collision or during heavy
braking.

Do not install display mount bracket into vehicle air vents as
damage will occur!