Philips SVB106AT - Manual (Page 44)

44 Hi-Fi Stereo Sound System
Multi-Channel Television Sound System broadcasts are automati-
cally recorded in Hi-Fi stereo sound. To play in Hi-Fi stereo tapes
recorded in Hi-Fi stereo, however, you’ll need to follow the steps
below. Make sure:
● The VCR is on and is in VCR position. The VCR/TV light will
appear. If it does not, press the VCR/TV button once.
3
Press the PLAY button or the STOP button repeatedly to
select HIFI. [ON] will appear to the right of HIFI on the screen.
• All programs are automatically
recorded in both Hi-Fi stereo sound
and in monaural sound.
• The audio level of a tape recorded in
Hi-Fi stereo will differ from the audio
level of a tape not recorded in Hi-Fi
stereo.
• Normally, HIFI should be selected
from the AUDIO OUT menu for play-
back with Hi-Fi sound. But, you can
change the selection to MONO if you
want monaural audio playback. To
do this, follow steps 1-2 above. At
step 3, press the PLAY button or the
STOP button repeatedly to select
MONO. Press the COUNTER
RESET/EXIT button. HIFI will disap-
pear from the status display.
• If you play non-Hi-Fi tapes while the
VCR is set to HIFI, HIFI will not
appear on the status display and the
tape will play in monaural sound.
Please see additional notes on
page 47.
Helpful Hints
1
Press the MENU button repeatedly until MENU 2
appears.
2
Press the PLAY button or the STOP button repeatedly to
select AUDIO OUT. Then, press the F.FWD button.
4
Press the COUNTER RESET/EXIT button.
2
1
3
4
- M E N U 2 -
B AUDIO OUT
TV STEREO
[ON]
SAP
AUDIO OUT
B HIFI [ON]
MONO
AUDIO OUT
B HIFI [ON]
MONO