Philips SVB106AT - Manual (Page 39)

Time Search 39
The Time Search function allows you to go to a specific point on a
tape. You will enter the exact amount of playback time that you
wish to skip in order to reach the specified point.
Make sure:
● The VCR is on and is in VCR position. (The VCR/TV light will
appear. If it does not, press the VCR/TV button once.)
● There is a tape in the VCR.
1
Press the TIME SEARCH button.
2
Within 30 seconds, press the PLAY button, the STOP
button, or the TIME SEARCH button repeatedly until
your desired length of time appears. (Example: 2:50 for 2
hours 50 minutes) You may also press and hold the PLAY button
or the STOP button until you reach the desired length of time.
3
Within 30 seconds, press the REWIND button or the
F.FWD button. The VCR begins rewinding or fast forwarding to
the specified point. The time counts down on the screen beneath
TIME SEARCH as the searching progresses. When the tape finish-
es rewinding or fast forwarding, the VCR will start playback auto-
matically.
TIME SEARCH
- : - -
• You can set a Time Search for up
to 9 hours, 59 minutes (9:59).
• Time Search is not available during
recording.
• To exit Time Search mode, press
the COUNTER RESET/EXIT button.
• To cancel a Time Search already in
progress, press the STOP button.
• If the end of the tape is reached
during a Time Search, the VCR will
cancel the search and rewind the
tape. Details are on page 41.
Helpful Hints
2
3
TIME SEARCH
2 : 5 0
1
TIME SEARCH
2 : 5 0
D