MITSUBISHI ELECTRIC 148 Series - Manual (Page 26)

26 3. TV Connections
Connect either an S-Video or composite video 6.
cable from VIDEO OUT on the VCR back panel
to a VIDEO composite or S-VIDEO jack on the TV
main panel. Connect only one type of video cable.
S-Video is preferable to composite video, if avail-
able.
To use the TV speakers with the VCR, connect left 7.
(white) and right (red) audio cables from AUDIO OUT
on the VCR back panel to the associated INPUT
AUDIO L and R on the TV main panel. If your VCR
is mono (non-stereo), connect only the white (left)
cable.
Note: When using this connection configuration with the
connections used in step 5, it is possible to view
live cable programs through the VCR Device. For
best picture quality always view live cable programs
directly from the TV input connected to the cable
box device.
Older Cable Box
Required: One coaxial cable.
Note: This connection is not recommended. The
other connections described in this chapter
provide better quality audio and video to the TV
and allow NetCommand to work with the cable
box.
Connect the incoming cable to 1. IN on cable box.
Connect one coaxial cable from 2. OUT on the cable
box to ANT 1 on the TV main panel.
HDMI
4
3
2
1
IR-
Output / External Controller Input
S-VIDEO
VIDEO
AUDIO
L
R
INPUT3
INPUT2 INPUT1
L R
AVR AUDIO
OUTPUT
AUDIO
L
R
Pb
Y Y / VIDEO
Pr
ANT2/AUX ANT1/MAIN
DIGITAL AUDIO
OUTPUT
NetCommand
) i 0
8 0
1 /
p 0
2 7 /
p
0 8 4 / i
0 8
4 (
AUDIO
R
DVI/PC
L
ANT1/MAIN
ANT1/MAIN
IN
OUT
Cable
box
TV main panel
2.
2.
1.
Incoming
cable
Figure 10. Connecting an older cable box