Motorola F5207A - Manual (Page 9)

9
Section 2: Basic Operations
This section describes the following operations:
• Power On
• Power Off
• Standby
• Wake Up
• Reset
Power On
This chapter describes methods to power on the CPU box in normal and extreme
conditions.
NOTE: Prior to powering on the CPU, ensure that the main power switch on the rear
CPU panel is in the ON position.
Normal operation
The CPU box can be turned on either from the vehicle ignition switch or by the
power button located on the front panel.
• If the CPU box power is connected directly to the battery (and not through
the ignition switch) and configured to be turned on/off only by the power
button (see section 3, Ignition boot up preference setting is NONE), press
the Power button on the front panel of the CPU box.
• If the CPU box power is connected through the ignition and configured to be
turned on/off by both the ignition switch and the power button (see section 3,
Ignition boot up preference setting is POWER ON), insert the car key into
the ignition switch and rotate it to ACC position or press the Power button on
the front panel of the CPU box.
• If the CPU box power is connected through the ignition and configured to be
turned on/off only from the ignition switch (see section 3, Ignition boot up
preference setting is POWER BUTTON LOCK), insert the car key into the
ignition switch and rotate it to ACC position.
When the CPU is turned on, the pre-installed Operating System will be automatically
loaded. This process takes some time; please wait until this process is completed
before using the computer.