Motorola F5207A - Manual (Page 17)

17
Selects initial mode of a GPS receiver if your CPU is fitted with the internal Trimble
GPS unit. Factory setting is OFF.
GPS mode
This parameter is pertinent if your CPU is fitted with the internal Trimble GPS
device. It selects the standard protocol used by GPS receiver to transmit data. The
NMEA and TSIP/TAIP options are available. Factory setting is TSIP/TAIP for
F5207A and NMEA for F5217A.
Radio ring indicator (RI)
Enables or disables wake-up from the RI line of the serial COM3 port. Factory
setting is ENABLE.
System ring indicator (RI) mask
Masks Ring Indicator from any serial port. When masking is disabled, RI from any
serial port will wake up the device. Factory setting is DISABLE.
Note: for serial COM3 port, see also Radio ring indicator (RI) parameter.
iDEN programming mode
This parameter is pertinent if the device is fitted with an internal iDEN modem. It
turns on or off a special programming mode of the iDEN modem. Factory setting is
OFF.
SB9600 mode
This parameter is pertinent if the device is fitted with an internal iDEN modem and
allows a data in SB9600 format to be encapsulated. Factory setting is ON.
Heater optimization
The CPU has internal hard disk heater, which allows operating in low temperatures.
This parameter optimizes automatic heating, based on the ambient temperature in
your area. Factory setting is 0°F.
Hard disk heating when device is off
An internal automatic hard drive heater allows the CPU to operate properly in low
temperatures. When the device is turned off, an automatic heater will maintain the
hard drive temperature within the operating range for a certain period of time set by
this parameter. The period range is 0 to 16 hours. Factory setting is 16 hours.
CPU serial number
This read-only field shows the CPU serial number.
Refer to Appendix H for factory setting of the CPU configuration parameters.