Mitel 5312 - Manual (Page 25)

Mitel ® 5312/5324 IP Phone User Guide – Issue 2, June 2010 Page 11
Getting Started
Making and Answering Calls Using the Analog Button
To make a call using the Analog line:
1. Lift the handset.
2. Press the button you programmed as Analog Line. ANALOG CALL appears.
3. Dial the number.
To answer a Call using the analog line:
1. Lift the handset.
2. Press the Analog Line button that is highlighted.
To answer a waiting call on the analog line:
To answer a waiting analog call or return to the original analog call:
1. Do one of the following:
• Press and release the hookswitch.
• Press the Star button (
*
) to cancel.
2. Press the button you have programmed as Analog Line.
To put a current call on hold to answer an incoming analog call:
Press the highlighted Analog Line button.
To switch between the current call and the held call when one of the calls is using the
analog line, do one of the following:
• If your current call is using the analog line, press the flashing Line button of the held call.
The analog call is automatically put on hold.
• If your current call is using an IP line, press the highlighted Analog Line button. The IP
line is automatically put on hold.
To end a current call when an incoming analog call arrives:
Press the Star button (
*
) and then press the highlighted Analog Line button. The current
call ends and you are connected to the caller on the analog line.
To end the current analog call when an incoming call arrives:
Press the Star button (
*
) to cancel. The current analog call ends and you are connected
to the new caller.
NOTE
When you make an external call over the analog line, a prefix dialing number is not
required. If your IP phone’s Analog Line button has the Privacy option enabled, you
cannot access the analog line when another phone is using the analog line (button is
solid orange).To access the analog line, the user of the other phone must first hang
up. To determine whether the Privacy option is enabled, contact your System
Administrator.
NOTE
If you have subscribed to an analog call waiting service, you may use the hookswitch
or press the Star button (
*
) to answer a waiting analog call. When you are on an
analog call and a waiting analog call arrives, you hear a beep. This feature may not
be supported in all regions.