Motorola Netopia 3397GP - Manual (Page 191)

191
set security ipsec tunnels name "123" remote-id id_value
Specifies the NAT remote ID value as specified in the remote-id-type for the specified IPsec tunnel,
when Aggressive Mode is set.
☛
Note: If subnet is selected, the following two values are used instead:
set security ipsec tunnels name "123" remote-id-addr ip-address
set security ipsec tunnels name "123" remote-id-mask ip-mask
Internet Key Exchange (IKE) Settings
The following four IPsec parameters configure the rekeying event.
set security ipsec tunnels name "123" IKE-mode
ipsec-soft-mbytes (1000) {1-1000000}
set security ipsec tunnels name "123" IKE-mode
ipsec-soft-seconds (82800) {60-1000000}
set security ipsec tunnels name "123" IKE-mode
ipsec-hard-mbytes (1200) {1-1000000}
set security ipsec tunnels name "123" IKE-mode
ipsec-hard-seconds (86400) {60-1000000}
◆
The soft parameters designate when the system begins to negotiate a new key. For example, after
82800 seconds (23 hours) or 1 Gbyte has been transferred (whichever comes first) the key will
begin to be renegotiated.
◆
The hard parameters indicate that the renegotiation must be complete or the tunnel will be dis-
abled. For example, 86400 seconds (24 hours) means that the renegotiation must be complete
within one day.
Both ends of the tunnel set parameters, and typically they will be the same. If they are not the same,
the rekey event will happen when the longest time period expires or when the largest amount of data
has been sent.