Motorola Phone i500plus User Manual
Page 48

42
i500plus User’s Guide
Desktop Charger Troubleshooting
If the battery is not charging and you see:
A flashing yellow indicator -
•
The flashing yellow LED is used to indicate that the Charger’s
pocket is in a wait state.
•
If a battery is in the rear pocket, the rear pocket’s LED
continues to flash yellow until the battery in the front pocket is
more than 90% charged (front pocket’s LED is solid green).
This is normal operation.
•
To protect your battery’s life expectancy, the Charger does not
rapid charge a battery when its temperature is below 5
o
C
(41
o
F) or above 45
o
C (113
o
F).
No LED indication -
•
Check that the
i500plus
with battery, or a battery alone, is
inserted correctly.
•
Make sure that the power supply is plugged into an appropriate
AC outlet and that the connector is properly seated.
•
Rear pocket only: Remove the battery from the Charger. Use an
ordinary pencil eraser to clean the three metal contacts on the
battery and then place the battery in the Charger.
•
If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Flashing red LED indicator -
•
Remove the battery from the Charger. Use an ordinary pencil
eraser to clean the three metal contacts on the battery and then
place the battery in the Charger.
•
If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Both LEDs flash red -
•
This indicates that the incorrect power supply is plugged in.