Melitta MES2B - Manual (Page 9)

9
8. Place a 32-ounce container below the Drip Spout to collect the
water.
9. Press the Power Light/Indicator Button to turn power on, then
simultaneously press the 5-ounce and 8-ounce Serving Buttons,
see Figure 8.
The water from the Water Tank will cycle through the One:One. ™
Note: If your One:One ™ goes unused for 3 or more days, please
repeat above process (steps 1 - 9).
CAUTION: Do not immerse cord, plug or machine in water or other
liquid.
Brewing Coffee or Tea
CAUTION: Before brewing in your One:One ™ for the first time,
complete the steps listed under “Before Using Your
One:One
™ Pod Brewing System” on pages 6 - 9 to ensure
your machine functions properly.
1. Fill the Water Tank with water up to the ‘MAX’ line. Never pour
other liquids such as milk or hot water into the Water Tank. A
full tank will yield up to 24-ounces of coffee or tea (three 8-
ounce mugs).
2. Press the Power Light/Indicator Button.The indicator light will
flash while the water heats up. Heating will take approximately
1-1/2 minutes.
3. To open the Lid, place one finger behind Lever and pull out.
Gently raise Lid to open position.
4. Assemble the Drip Spout to the Pod Chamber.
5. Place the Drip Spout Assembly inside the One:One.
™
FIGURE 8
MES2B/W/R/K/MG/CAN_IB_17-8-05 8/17/05 1:24 PM Page 15