Melitta MES2B - Manual (Page 11)

11
11. Press the desired Serving Button: for either a 5-ounce serving
or an 8-ounce serving. The machine will begin the brewing
process. At the beginning of the brewing cycle, a small amount of
water is dispersed to saturate the pod to ensure full extraction.
Following a pause, the machine will brew for about 50 seconds
for coffee (or 35 seconds for tea). You can manually stop the
brewing process at any time by pressing the Power Button.
CAUTION: Dripping may occur between brewing cycles.
12. Dispose of the javapod ™ or teapod ™ after use by removing the
Pod Holder from the Pod Chamber and emptying it. Do not use
a pod more than once. Repeated use may cause the pod to
burst and result in weak and inferior coffee or tea.
Note: Regular rinsing of the Pod Holder will optimize the flavor of
the beverage.
You may leave your One:One ™ on if you intend to brew another
cup of coffee or tea. The appliance will turn itself off automatically
after one hour.
Drip Spouts
Included for use in your One:One ™ Pod Brewing System is a Drip
Spout for coffee and/or tea. To maximize the flexibility of your
Brewing System and to avoid residual flavor when alternating
between coffees or teas, you may wish to purchase additional Drip
Spouts. Also available is a shorter Spout designed specifically for
Iced Tea (shown below). Order on-line at www.1to1coffee.com or call
toll free, 1-800-841-1628.
FIGURE 10
Iced Tea Spout Set:
(P/N 31095SET)
includes: Tea Pod Holder
Pod Chamber
Iced Tea Spout
Drip Spout Set:
(P/N 31003SET)
includes: Pod Holder
Pod Chamber
Drip Spout
MES2B/W/R/K/MG/CAN_IB_17-8-05 8/17/05 1:24 PM Page 11