Melitta MES2B - Manual (Page 10)

6. Place the Pod Holder inside the Pod Chamber. See Figure 6.
7. Place one Melitta
® javapod ™ or Cooper’s ® teapod ™ inside the
Pod Holder. Press lightly on the javapod ™ or teapod ™ to make
sure it sits evenly inside the Pod Holder.
IMPORTANT: Make sure the paper lip of the coffee pod is contained
within the Pod Holder and does not overhang on the rim.
See Figure 9.
CAUTION: Use only specially designed Melitta ® javapods ™ or
Cooper’s ® teapods ™ in your One:One ™ Pod Brewing
System. The use of loose ground coffee, pods or tea
bags not designed for the One:One.,
™ may result in poor
coffee or tea, and could possibly damage the machine.
CAUTION: Never use torn javapods ™ or teapods ™ as this could clog
the machine and damage it. Each javapod ™ or
teapod ™ is pre-portioned with the optimal amount of
coffee or tea required per cup.
8. To close the Lid, press down firmly on the top of the Lid and hold
in place while pushing the Lever back so it is flush with the Lid
and locks into place. See Figure 7.
CAUTION: Make sure the Drip Spout Assembly is in position inside
the One:One. ™
9. Place a mug or cup under the Drip Spout. The cup should hold
at least 7 to 10 ounces, depending on your selection.
10. When the indicator light stops flashing, the appliance is ready
to use. If the indicator light flashes at rapid intervals, see
troubleshooting on page 14.
Note: Use one javapod ™ to brew either one 5-ounce, bold European
serving, or one 8-ounce serving of American-style coffee.
When brewing tea, be sure to select the 8-ounce serving.
10
correct incorrect
correct
FIGURE 9
MES2B/W/R/K/MG/CAN_IB_17-8-05 8/17/05 1:24 PM Page 12