Moxa Technologies MGATE EIP3000 DF1 - Manual (Page 36)

MGate EIP3000 Series User’s Manual Configuring the EtherNet/IP Gateway
ATTENTION
To erase an existing password, leave both the New Password and Confirm Password text input
boxes blank. The password will be erased when you click OK in the bottom right corner.
Configure Serial Communication Parameters
The Serial tab is where each serial port’s communication parameters are configured. You can
configure Baud Rate, Parity, Stop Bit, Flow Control, FIFO, and Interface Mode.
Parameter Value
RS-232
Interface Mode
RS-422
Baud Rate 1200 bps to 961200 bps
Parity None, Odd, Even
Stop Bits 1, 2
Flow Control None, DTR/DSR, RTS/CTS
UART FIFO Enable, Disable
5-12