Centre frequency response, configuring, Centre tilt offset, configuring, Settings, storing – Meridian America Meridian DSP User Manual
Page 41: Storing settings, Tilt offset, configuring, C.fre, C.tilt+1, Store
36
CONFIGURING THE
DSP LOUDSPEAKERS
To adjust the centre frequency response and tilt offset
If your system includes a DSP centre speaker you should set Centre Y on
the master speaker. An additional frequency response option is then
provided to allow you to adjust the centre speaker, with the options:
C.Fre, C.bou, C.Sb1, C.Sb2, and C.Cor.
• Press Function
> or Function < until the display shows the current
centre frequency response.
For example:
C.Fre
• Press Function
A or Function V to select the appropriate option for
the centre speaker.
An additional centre tilt offset option is also provided. The centre tilt offset
is added to the treble value for the selected source. The recommended
setting is -1dB when the speaker is positioned above a television.
• Press Function
> or Function < until the display shows the current
centre tilt offset.
For example:
C.Tilt+1
• Press Function
A or Function V to adjust the centre tilt offset.
To store the settings
Once you have adjusted the frequency response for the speakers in your
system you should store the settings using the following procedure:
• Press Function Store.
The display shows:
Store
• Turn off the DSP loudspeaker using the power switch on the back panel.
When you turn on the power again the speaker will operate normally with
the frequency response settings you have stored.