Meridian America Meridian DSP - Manual (Page 21)

16
SETTING UP THE DSP
LOUDSPEAKERS
• When all four feet have been fitted, carefully set the DSP loudspeakers
upright in their playing positions and remove the rest of the packaging.
To fit the rubber bumpons (DSP5000C and DSP5500HC
only)
• Attach four bumpons to the underside of each speaker, using the self-
adhesive pads.
To install the head units (DSP6000 or DSP6000C only)
• Locate the three pillars and screw them into the three holes in the top
of each base unit.
• Fit the glass plate over the pillars on the top of each base unit.
• Fit a plastic spacer over each pillar.
• Place the head unit on top of each base unit.
On the DSP6000 the gold stripes on the head and base units should line up.
The speakers have the correct orientation if the sloping sides on the heads
are to the outside (gold strip inside).
• Connect the end of each head connection lead marked with a red band
to the socket in the back of the head unit.
• Connect the other end of each lead to the socket on the back of the
base unit.
To dismantle the loudspeakers (DSP6000 or DSP6000C
only)
When dismantling the speakers always switch off and disconnect the power
first, then disconnect the head unit from the base unit.
Note: Do not disconnect the head lead while the unit is connected
to the AC supply and switched on.
It is advisable to remove the head units when moving the speakers. This is
achieved by disconnecting the head lead from the base unit and lifting off
the head. Take care while the head is not in position as this exposes its
mounting spikes. While not in place the head should be stored safely but
care should also be taken of the surface they are placed upon as it may be
damaged by the cups.