MITSUBISHI ELECTRIC WD-52527 - Manual (Page 40)

0
Chapter 3. NetCommand Setup and Editing
NetCommand ® Initial Setup
When you first power On your new Mitsubishi TV, the
initial setup screens appear. The process allow you
to quickly set up NetCommand and the TV Guide On
Screen® system. Most IR remote control signal formats
can be learned by NetCommand.
Welcome Screen
Figure 1
When you first turn on your TV, the NetCommand
Welcome screen displays and asks you to select either
English or Spanish as the language for the on-screen
menus. The default language is English. To change
Language later, select Setup in the Main Menu. Selecting
Cancel at this screen will cause the default language
(English) to be selected.
NetCommand (Information) Screen
Figure 2
The NetCommand (Information) Screen describes how
to start or delay the initial NetCommand and TV Guide
On Screen setup. This screen displays automatically
the first time you power On your new TV, after the
Welcome screen.
IMPORTANT
You may use your TV without setting up
NetCommand or the TV Guide On Screen®
system. To set up at a later time, choose the
NetCommand menu from the Main menu, then
select Initial. The TV Guide On Screen system
is set up from the NetCommand menu.
Figure 2. Information screen
Figure 1. Welcome screen
Select Next> and press ENTER to start the initial setup.
If the NetCommand Setup is cancelled before it’s
completed, you can restart the NetCommand setup by
1. A press of TV MENU on the remote control to display
the TV Main menu.
2. Select NetCommand. The available options will be:
Add, Review, Guide or Initial. Change and Delete will
be grayed out.
3. Press ADJUST , , or to select Initial.
4. Press ENTER. The Device Setup screen (shown on
the next page) displays.
NetCommand must be set up and the IR
emitters properly placed for your cable box
and VCR so the TV Guide On Screen system
can control these devices.
IMPORTANT