Miele CVA 3650 EN - Manual (Page 65)

All electrical work should be carried out
by a suitably qualified and competent
person only, in strict accordance with
current national and local safety
regulations (BS 7671 in the UK).
Installation, repairs and other work by
unqualified persons could be
dangerous. The manufacturer cannot
be held liable for unauthorised work.
Ensure power is not supplied to the
machine until after installation work has
been carried out.
The voltage and connected load are
given on the data plate. Please ensure
these match the household mains
supply. The fuse rating is quoted on the
plug.
The machine is supplied with a mains
cable with moulded plug for connection
to a 230 - 240 V mains supply.
Connection should be made via a fused
plug and suitable switched socket
which is easily accessible after
installation.
Do not connect via an extension lead.
For extra safety it is advisable to protect
the appliance with a suitable residual
current device (RCD). Contact a
qualified electrician for advice.
If the socket is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
WARNING: THIS APPLIANCE
MUST BE EARTHED
Non-rewireable plugs BS 1363
The fuse cover must be refitted when
changing the fuse, and if the fuse cover
is lost, the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words on the base of the
plug (as applicable to the design of
plug fitted).
Replacement fuses should be ASTA
approved to BS 1362 and have the
correct rating. Replacement fuses and
fuse covers may be purchased from
your local electrical supplier.
Do not connect the machine to an
inverter such as those used with an
autonomous energy source e.g. Solar
power.
When switched on peak loads in the
system can cause the safety switch off
mechanism to be triggered. This can
damage the electronic unit.
The machine must not be used with
so-called Energy saving devices
either. These reduce the amount of
energy supplied to the machine
causing it to overheat.
Electrical connection U.K., ZA, IRL
65