Multiquip MQ Power Whisperweld DC Welder/AC Generator SGW-250SS - Manual (Page 6)

PAGE 6 — SGW-250SS DC WELDER/AC GENERATOR— PARTS & OPERATION MANUAL — REV. #2 (08/08/01)
RULES FOR SAFE OPERATION
CAUTION:
Failure to follow instructions in this manual may
lead to serious injury or even death! This
equipment is to be operated by trained and
qualified personnel only! This equipment is for
industrial use only.
The following safety guidelines should always be used when
operating the SGW-250SS Welder/AC Generator :
GENERAL SAFETY
■ DO NOT operate or service this equipment before
reading this entire manual.
■ This equipment should not be operated by
persons under 18 years of age.
■ NEVER operate this equipment without proper
protective clothing, shatterproof glasses, steel-
toed boots and other protective devices required
by the job.
■ NEVER operate this equipment when not feeling
well due to fatigue, illness or taking medicine.
■ NEVER operate this equipment under the
influence or drugs or alcohol.
■ NEVER use accessories or attachments, which are not
recommended by MQ Power for this equipment. Damage to
the equipment and/or injury to user may result.
■ Manufacture does not assume responsibility for any accident
due to equipment modifications.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■ Always check the machine for loosened threads or bolts
before starting.
■ Always refuel in a well-ventilated area, away from sparks and
open flames.
■ Always use extreme caution when
working with flammable liquids. When
refueling, stop the engine and allow it
to cool. DO NOT smoke around or near
the machine. Fire or explosion could
result from fuel vapors, or if fuel is
spilled on a hot engine.
■ NEVER operate the generator in an explosive atmosphere
or near combustible materials. An explosion or fire could
result causing severe
bodily harm or even death.
■ Topping-off to filler port is dangerous, as it tends to spill
fuel.
■ NEVER touch the hot exhaust
manifold, muffler or cylinder. Allow
these parts to cool before servicing
engine or generator.
■ The engine of this welder/generator requires an adequate
free flow of cooling air. Never operate the generator in any
enclosed or narrow area
where free flow of the air is
restricted. If the air flow is
restricted it will cause serious
damage to the welder/
generator engine and may
cause injury to people.
Remember the welder/
generator's engine gives off
DEADLY carbon monoxide
gas.
■ High Temperatures – Allow the engine to cool before
adding fuel or performing service and maintenance
functions. Contact with
hot components can cause serious
burns.