Sgw-250ss — preparation for long -term storage – Multiquip MQ Power Whisperweld DC Welder/AC Generator SGW-250SS User Manual
Page 34
PAGE 34 — SGW-250SS DC WELDER/AC GENERATOR— PARTS & OPERATION MANUAL — REV. #2 (08/08/01)
Welder/Generator Storage
For storage of the generating set for over 30 days, the
following is required:
z Drain the fuel tank completely.
z Run the engine until the gasoline in the carburetor is
completely consumed.
z Completely drain the oil from the crankcase and refill
with fresh oil.
z Remove the spark plug, pour 2 or 3 cc of SAE 30 oil
into the cylinder and crank slowly to distribute the oil.
z Slowly rotate the engine a few times with the and install
a new plug.
z Remove the NEGATIVE battery cable from the negative
post on the battery.
z Stop the engine at the compression point.
z Clean all external parts of the generating set with a cloth.
z Cover the generating set and store in a clean, dry place.
SGW-250SS — PREPARATION FOR LONG -TERM STORAGE