MaxTech NX-16 - Manual (Page 4)

2
Minimum hardware requirements are an
IBM PC/XT (or better) fully compatible PC with
512K RAM running DOS 3.3 or higher. The
network operating system you use may have higher
requirements.
Section Two - Installation
This section will provide step by step in-
structions on how to install your new Maxtech
network adapter. Installation of this network adapter
is a two-step process consisting of actual hardware
installation and card configuration. This network
adapter is designed to be configured using the soft-
ware included on the installation diskette, eliminat-
ing any time-consuming jumper/switch settings.
2.1 Unpacking Your Network Adapter
Three types of network adapter cards are
available. Before you proceed, determine the model
you have purchased. The following table summa-
rizes the contents and features for your Maxtech
Ethernet product:
Model
NX- NX- NX-
16T 16B 16BT
Adapter Card x x x
RJ-45 x x
BNC x x
LED (LINK) x x
BNC T-connector x x
Boot ROM Socket x x x
Installation disk x x x
User's Guide x x x