Metrologic Instruments StratosS MS2220 - Manual (Page 20)

14
I NSTALLATION
U NPACKING THE U NIT
MS2220 Package Warning
There is a protective film located on the topside platter surface, vertical scan windows outer surface, and the horizontal scan
windows top surface. These protective films must be removed prior to performing any scanner operation (see Figure 15).
Both foam wedges securing the scale arms during shipping must be removed or the scale will not function (see Figure 15)!
Figure 15. Protective shipping foam and lining.
Do not discard these instructions and shipping foam wedges! If the unit is going to be reshipped at any time
this foam must be reinstalled prevent damage to the scale arms during shipping.
I NSTALLING THE U NIT IN THE C OUNTER
Before starting to mount the StratosS determine:
• the scanner's orientation in reference to the operator and the direction of package flow,
• the mounting method that provides the most stability for the scanner and
• if any additional materials or tools are required for installation.
Lifting the Unit by the Finger Recesses
There are two finger recesses located under the removable
platter near the base of the vertical window. These finger
recesses are provided to assist in installation when placing the
unit in the checkout counter cutout (See Figure 16).
To decrease the risk of dropping the unit during
installation, rest both thumbs against the vertical window
frame for added stability when lifting the unit by the finger
recesses. The unit may tilt forward when lifted by the finger
recesses if it is not stabilized making installation in the
countertop cutout difficult.
Figure 16. Lifting the Unit by the Finger Recesses