MicroBoards Technology QD-123 - Manual (Page 8)

8
1. Copy
Copying – 52x 18%
150.4MB 01:15
2. Test
3. Test & Copy
Testing – 52x 18%
150.4MB 01:15
1.0 Copy
OK: 07
2.0 Test
OK: 07
Functions
There are 9 different functions for the QD-MultiDrive duplicator: Copy, Test, Test & Copy,
Verify, Compare, Prescan, Disc Info, Edit Track and Setup. For the Setup options, please
refer to page 12.
These instructions refer to using 7 recorder drives (available only in the QD-127), but the QD-
MultiDrive will operate using any number of the available recorder drives.
Copy
Please refer to pages 15-17 for CD+G duplication
The Copy function is used to copy our master disc to the blank media, CD-R or
CD-RW. The QD-MultiDrive duplicator will be in Copy mode when it is turned
on. The display will read:
Place your master disc into the CD reader drive.
Place your blank media into the CD Recorder drives.
Press the ENT button on the controller interface.
The data will now be copied to the blank discs.
When the job is completed, the recorded discs will be ejected from the
recorder drives. The display will read:
Test
The Test function is used to simulate copying our master disc to the blank media,
CD-R or CD-RW. To use the Test function, press the ▼ button on the controller
until Test is displayed:
In Test mode, the blank media will remain blank and can be used again.
Place your master disc into the CD reader drive.
Place your blank media into the CD Recorder drives.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank discs.
When the job is completed, the recordable discs will be ejected from the
recorder drives. The display will read:
Test & Copy
The Test and Copy function will perform both operations, one after the other. If the Test
portion passes without errors, the system will automatically start the Copy process.
To run the Test and Copy function, press the ▼▲ buttons until the
display reads:
Place your master disc into the CD reader drive.
Place your blank media into the CD Recorder drives.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank discs.
Testing – 52x 18%
150.4MB 01:15