MicroBoards Technology QD-123 - Manual (Page 11)

11
Continue Edit
Next disc? NO
Continue Edit
Next disc? NO
8. Edit Track
8. Press the ESC button to take you to this screen:
If you wish to continue to add more audio tracks to the disc in
the recorder drive, press the ▼ button to change the NO to YES.
Then press Enter.
The TOP reader drive will open and ask you to put in the next master disc. Place the new
disc into the drive and close the tray. Go to step 3 and repeat the process.
Once you have completed copying the audio tracks to the Recorder drives, you will need to
close the discs.
9. At this screen, leave the selection as NO and press ENT:
Once ENT is pressed, the following screen appears:
10. Press the ENT button. The following screen appears:
Once the discs are closed, the following screen appears:
Close Session
The Close Session function is used only if you did not close an audio CD, as described in the
Edit Track / CD to CD Edit section. You can use this function to manually close the disc.
To use the Close Session function, press the ▼▲ buttons until the
display reads:
Press the ENT button. The following screen appears:
Press the ▼ button until the display reads:
Make sure your recorded audio CDs are in the Recorder drives.
Press the ENT button. The following screen appears:
Press the ENT button. The following screen appears:
Once the discs are closed, the following screen appears:
Close all disc’s
Sessions? Yes
Closing Session
Please wait….
Close Complete
OK: 07 Fail: 00
8-01. Edit Track
CD to CD Edit
8-03. Edit Track
Close Session
Close all disc’s
Sessions? Yes
Closing Session
Please wait….
Close Complete
OK: 07 Fail: 00