Meridian America 507 - Manual (Page 30)

Configuring the compact disc player
25
Specifying information about your system
You can configure the operation of the 507 Compact Disc Player
to suit the way your system is set up, and the way in which you
want to use it.
These settings are configured automatically to appropriate
values when you choose the standard type settings, and you
should not normally need to alter them; see Choosing standard
settings, page 24.
To configure the compact disc player
● Switch off the compact disc player, using the power switch on
the back panel.
● Switch on the power again while holding down Display (front
panel).
The display will initially show the
software revision number, then:
Config
It will then show the first
configuration option:
500
● Press Display to move between the options.
● Press [ or ] to change the value of the current option.
● Switch the power off and then on again, using the power
switch on the back panel, to store the settings.
The table below shows the options you can configure:
Option Initial Value
Comms type (500 or 200).
500
Controller mode (Auto, Con, or NCon).
Auto
System address (1–8).
S.A. 1
Product address (1–8).
P.A. 1
Start source.
S.S. CD
Volume displays (Y or N).
Vol N