Metz 42TN92 - Manual (Page 28)

- 58 -
Remote Control
Your TV no longer responds to the remote
control. Perhaps the batteries are ex-
hausted. If so you can still use the local but-
tons at the bottom of the TV.
Have you selected the wrong menu? Press
the
button to return to TV mode or press
the “M” button to return to the previous
menu.
No solution:
Switch your TV set off and on. If this does not
work, call the service personnel; never at-
tempt to repair it yourself.
Tips
Care Of The Screen
Clean the screen with a slightly damp, soft
cloth. Do not use abrasive solvents as they
may damage the TV screen coating layer.
Poor Picture
Have you selected the correct TV system? Is
your TV set or house aerial located too close
to non-earthed audio equipment or neon
lights, etc.?
Mountains or high buildings can cause
double pictures or ghost images. Some-
times you can improve the picture quality by
changing the direction of the aerial.
Is the picture or Teletext unrecognisable?
Check if you have entered the correct fre-
quency.
The picture quality may degrade when two
peripherals are connected to the TV at the
same time. In such a case, disconnect one
of the peripherals.
No Picture
Is the aerial connected properly? Are the
plugs connected tightly to the aerial socket?
Is the aerial cable damaged? Are suitable
plugs used to connect the aerial? If you are
in doubt, consult your dealer.
No Picture could mean that your TV is not
receiving a transmission. Have you selected
the correct button on the remote control? Try
once more.
Sound
You can not hear any sound. Did you per-
haps interrupt the sound, pressing the
button?
Sound is coming from only one of the
speakers. Is the balance set to one ex-
treme? See Sound menu.