Motorola D210 - Manual (Page 24)

22
English
4. Press or to select the base number.
Press .
Resetting your phone
If you reset your phone, both the base and handset will return
to their pre-set (default) settings. If you have more than one
handset registered to your base and you complete the
following procedure, only the handset you reset and the base
will go back to the default settings.
For the base:
1. Press to access the main menu.
2. Press or to select " BS SETTINGS" and press .
3. Press or to select " BS DEFAULT" and press .
4. " PIN ?" appears. Enter your PIN code. Press .
The base will reset and the handset will return to standby
mode.
For the handset:
1. Press to access the main menu.
2. Press or to select " HS SETTINGS" and press .
3. Press or to select " HS DEFAULT" and press .
4. " PIN ?" appears. Enter your PIN code. Press .
The handset will reset and the handset returns to the standby.
12. Default settings
13. Network services
To use caller ID or any other services detailed in this section,
you must first contact your network provider and subscribe to
the relevant service.
Caller ID
With caller ID the caller's number is shown in the handset
display as you receive an incoming call so you can see who is
calling before you pick up the phone.
Ringer Volume 2
Earpiece Volume 3
Speaker Volume 3
Base Ringer Type 1
Alarm OFF
Tone Key
Tone ON
Battery Low ON
Range Alarm ON
Auto Answer ON
Language ENGLISH
Dial Mode
TONE
Flash Time SHORT
Base PIN 0000
Answering Machine
Answer ON/OFF
ON
Message Alert ON
Ring delay 4 rings
Remote operation PIN 0000
Guidance Language
English
Allegro_CID TAD.book Page 22 Tuesday, January 15, 2008 4:30 PM