Motorola D210 - Manual (Page 23)

21
English
On the handset you want to register:
5. Press .
6.
"PIN ?" appears. Enter the base PIN code. The pre-set base
PIN code is 0000.
7. Press .
You will hear a confirmation tone when registration is
complete.
When in standby mode, the new handset number will be
displayed.
The handset will automatically be allocated with the next
available handset number.
If the registration fails, the handset display returns to the
display of before the registration.
De-register a handset
If you have more than one handset registered to your base,
you can de-register a handset.
Before de-registering, make sure all handsets and the base are
in standby mode.
1. On a handset not to be de-registered, press to
access the main menu.
2. Press or until "
BS SETTINGS" is displayed and press
.
3. Press or to display " TERMINATE HS" and press .
4. "PIN ?" is displayed. Enter your PIN code and press .
5. Press or to display the handset you want to de-register
and press .
If the handset has been de-registered from the base
successfully, you will hear a confirmation tone.
Base PIN code
You need to enter the base PIN code when you are registering
handsets. For security reasons you may wish to change the
PIN code. You can choose a PIN code up to 4 digits long. If you
reset the base from the handset, the base PIN code will be
0000.
Always keep a record of your base PIN code. Note your PIN
code and keep it in a safe place. If you change the PIN code you
will need to use the new code for any handset registered to
your base.
1. Press to access the main menu.
2. Press or to select " BS SETTINGS" and press .
3. Press or to select " MODIFY PIN" and press .
4. Enter the current PIN code using the number keypad and
press .
5. " NEW PIN" appears. Enter a new PIN code and press .
6. " CONFIRM" appears. Re enter a new PIN code. Press .
Selecting a base
You can register a handset to up to 4 bases, e.g. one at work
and one at home, and switch between them. Once your
handset is registered with other bases, you can specify the
base you want to use.
1. Press to access the main menu.
2. Press or to select " HS SETTINGS". Press .
3. Press or to select " SELECT BASE". Press .
Allegro_CID TAD.book Page 21 Tuesday, January 15, 2008 4:30 PM