Motorola D210 - Manual (Page 12)

10
English
Receive a call
When you receive a call the handset and base will ring. The
icon will flash in the handset display.
If you have subscribed to a Caller ID service through your
network supplier, the caller's number will be displayed (if
available). If you store the number and name in the phonebook
and the number matches with that of the Caller ID, the Caller
name will appear and private ring will sound (if available). See
page 22 and 26 for further information on caller ID.
1. Press or to answer the call.
Or simply lift the handset from the base (providing auto
answer is set to On, see page 18).
After a short delay the call timer will start timing the call.
Call Waiting
If you subscribe to Call Waiting and the call waiting tone
sounds during a call, press
to switch between callers.
Receiving internal calls
If you receive a call from another handset, the icon and the
internal caller's handset number will be displayed.
Redial
Your handset saves the last 10 numbers called into a redial list.
You can select and redial any number from the list at a later
time. Each handset has its own redial list.
Numbers stored in the redial list can be up to 32 digits long.
From standby mode:
1. In standby mode, press
to display the last number
called.
2. Press or to display any of the last 10 numbers called.
3. Press to dial the displayed number.
From talk mode:
1. Press .
2. Press and hold
to display the last number called.
3. Press or to display any of the last 10 numbers called.
4. Press to dial the displayed number.
Store a redial number to the phonebook
1. In standby mode, press
to display the last number
called.
2. Press or to display the redial number you want.
3. Press , then select " ADD TO PB", and then press .
4. " NAME ?" is displayed.
Enter a name using the keypad and press .
For information on entering names, see page 11.
You can enter a name of up to 12 characters.
Press to delete an incorrect letter.
5. The number is displayed again, press .
6. Select distinctive ring if required. Press or to select a
ringer. Press .
You will hear a beep to confirm the entry is stored.
Deleting numbers from the redial list
1. In standby mode, press
to display the last number
called.
2. Press or to display any of the last 10 numbers called.
3. With the number you want displayed, press .
Allegro_CID TAD.book Page 10 Tuesday, January 15, 2008 4:30 PM