Test program—developing hello.c, Installing the tool chain (linux), Checking the flash memory space – Moxa Technologies UC-7420/7410 User Manual
Page 33: Test program—developing hello.c -13, Installing the tool chain (linux) -13, Checking the flash memory space -13, Test program — developing hello.c
UC-7420/7410 User’s Manual
Getting Started
2-13
Test Program—Developing Hello.c
In this section, we use the standard “Hello” programming example to illustrate how to develop a
program for UC-7420/7410. In general, program development involves the following seven steps.
Step 1:
Connect UC-7420/7410 to a Linux PC.
Step 2:
Install Tool Chain (GNU Cross Compiler & glibc).
Step 3:
Set the cross compiler and glibc environment variables.
Step 4:
Code and compile the program.
Step 5:
Download the program to UC-7420/7410 Via FTP or
NFS.
Step 6:
Debug the program
Æ If bugs are found, return to Step 4.
Æ If no bugs are found, continue with Step 7
Step 7:
Back up the user directory (distribute the program to
additional UC-7420/7410 units if needed).
x
x86
Cross
Compiler
Installing the Tool Chain (Linux)
The PC must have the Linux Operating System pre-installed before installing the UC-7420/7410
GNU Tool Chain. Redhat 7.3/8.0, Fedora core, and compatible versions are recommended. The
Tool Chain requires about 100 MB of hard disk space on your PC. The UC-7420/7410 Tool Chain
software is located on the UC-7420/7410 CD. To install the Tool Chain, insert the CD into your
PC and then issue the following commands:
#mount /dev/cdrom /mnt/cdrom
#rpm –ivh /mnt/cdrom/mxscaleeb-3.3.2-1.386.rpm
The Tool Chain will be installed automatically on your Linux PC within a few minutes. Before
compiling the program, be sure to set the following path first, since the ToolChain files, including
the compiler, link, library, and include files are located in this directory.
PATH=/usr/local/mxscaleb/bin:$PATH
Setting the path allows you to run the compiler from any directory.
NOTE
Refer to Appendix B for an introduction to the Windows Tool Chain. In this chapter, we use the
Linux tool chain to illustrate the cross compiling process.
Checking the Flash Memory Space
If the flash memory is full, you will not be able to save data to the Flash ROM. Use the following
command to calculate the amount of “Available” flash memory:
/>df –h