Minuteman UPS Enterprise Plus Series - Manual (Page 9)

8
English
REAR PANEL
1. The RS232 Communications Interface Port is for UPS monitoring and control.
2. The USB Communications Interface Port is for UPS monitoring and control.
3. The RJ11 REPO (Remote Emergency Power Off) Port is for UPS control.
4. The option slot is for option cards.
5. The External Battery Connector is for connecting External Battery Packs.
6. The output circuit breaker will trip in the event the load exceeds the UPS’s power rating.
7. The Battery Backup output power receptacles. The output receptacles are electrically
wired into two segments to support the "Load Shedding Function". The locking receptacle
does not support the Load Shedding Function. NOTE: The locking recptacle is not on all
models.
8. The input circuit breaker will trip in the event the load exceeds the UPS’s power rating.
9. The input power cord (120V models). The AC Power Inlet IEC320 (208V models).
10. The dipswitch is for setting the Inverter (On-Battery) output voltage.
11. The External Ground Stud is for connecting an external ground wire.
12. The R-J11/R-J45 modular connectors are used for 10/100 Base-T Network/single line
Phone/Fax/Modem protection.
Output Power Receptacles
E750RM2U NEMA 5-15P
Model #
E1500RM2U
E2000RM2U
E1000RM2U
E3000RM2U
E1500RMT2U
E3000RMT2U
NEMA 5-15P
NEMA 5-15P
NEMA 5-20P
NEMA L5-30P
NEMA L6-30P
NEMA 6-15P
6-NEMA 5-15R
6-NEMA 5-15R
6-NEMA 5-15R
6-NEMA 6-15R
6-NEMA 5-15/20R
1-NEMA L5-20R
6-NEMA 5-15/20R
1-NEMA L5-30R
6-NEMA 6-15/20R
1-NEMA L6-30R
Input Power Plug
(All power cords are 10ft)