Minuteman UPS Enterprise Plus Series - Manual (Page 8)

7
English
The Load Level Bar Graph (AC mode only) operates as follows:
LED #10: >10% load (green/red/yellow) LED will be green and illu-
minated when there is at least 10% of the rated capacity.
LED #30: >30% load (green/yellow) LED will be green and illumi-
nated when there is at least 30% of the rated capacity.
LED #50: >50% load (green/yellow) LED will be green and illumi-
nated when there is at least 50% of the rated capacity.
LED #70: >70% load (green/yellow) LED will be green and illumi-
nated when there is at least 70% of the rated capacity.
LED #90: >90% to approximately 109% load (red/yellow) LED will
be yellow and illuminated when there is approximately 90% of the
rated capacity to indicate that unit is near full capacity. The LED
will turn red at 110% load capacity to indicate an Overload condi-
tion.
The Battery Capacity Bar Graph (Battery mode only) operates as
follows:
LED #90: >90% battery capacity (red/yellow) LED will be yellow
and illuminated until the battery’s capacity drops below 80% ca-
pacity and then it will extinguish.
LED #70: >70% battery capacity (green/yellow) LED will be yellow
and illuminated until the battery’s capacity drops below 60% ca-
pacity and then it will extinguish.
LED #50: >50% battery capacity (green/yellow) LED will be yellow
and illuminated until the battery’s capacity drops below 40% ca-
pacity and then it will extinguish.
LED #30: >30% battery capacity (green/yellow) LED will be yellow
and illuminated until the battery’s capacity drops below 30% ca-
pacity and then it will extinguish.
LED #10: >30% battery capacity (green/red/yellow) LED will be yel-
low and illuminated until the unit issues a Low Battery Warning
Alarm and then it will turn red to indicate a Low Battery Warning.
The Multi-Function On/Off/Test Button functions as follows:
When the UPS is Off, press and release the On/Off/Test button
after one beep to turn the UPS On. NOTE: The input circuit
breaker MUST be in the on position for the 208V models.
When the UPS is On, press and release the On/Off/Test Button
after one beep to turn the UPS Off. NOTE: Turn the input circuit
breaker to the off position for the 208V models.
When the UPS is On, press and hold the On/Off/Test button for four
beeps, then release the button. The UPS will perform a 5-second
Self Test.