Metrologic Instruments Stratos MS2x20 Series - Manual (Page 21)

16
S
CALE
C
ONFIGURATION
B
AR
C
ODES
Dual Cable Scale Configuration Bar Codes
Scale Protocols
The following bar codes will change scale parameters intended for a
Dual Cable environment. To place the scanner in Dual Cable mode,
please refer to page 24.
If the MS2 xx0 is currently in a Dual Cable configuration, temporarily
disconnect the Scale to Host cable prior to configuring the scale.
The MS2 xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
*NCI = 4 Status Bytes
³ 9 9 6 0 5 2
Set the number of status bytes reported by
the NCI scale protocol to 4 status bytes.
* Factory Default Setting
NCI = 2 Status Bytes
³ 9 9 6 0 5 3
Set the number of status bytes reported by
the NCI scale protocol to 2 status bytes.