Metrologic Instruments Stratos MS2x20 Series - Manual (Page 14)

9
S
CALE
C
ONFIGURATION
B
AR
C
ODES
Single or Dual Cable Scale Configuration Bar Codes
Scale Internal Beeper
The following bar codes can be used to configure a Single or
Dual Cable MS2
xx0.
If the MS2 xx0 is currently in a Dual Cable configuration, temporarily
disconnect the Scale to Host cable prior to configuring the scale.
The MS2 xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
Scale Beep On
³ 9 9 6 0 9 0
Enable the internal scale beeper to beep
when remote display keys are depressed.
*Scale Beep Off
³ 9 9 6 0 9 1
Turn off the internal beeper inside the scale.
This is the desired default as the scanner
beeper is the main tone generator.
* Factory Default Setting